LS 460 AWD V8-4.6L (1UR-FSE) (2009)
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard Bolt -
Specified Torque For Standard Bolts.
1. TEMPORARILY INSTALL FRONT NO. 1 SUSPENSION UPPER ARM ASSEMBLY LH
(a) Insert the bolt as shown in the illustration. Then temporarily install the front No. 1 suspension upper arm assembly LH to the inner No. 1 arm
attachment plate LH with the nut.
2. TEMPORARILY INSTALL FRONT NO. 2 SUSPENSION UPPER ARM ASSEMBLY LH
(a) Insert the bolt as shown in the illustration. Then temporarily install the front No. 2 suspension upper arm assembly LH to the inner No. 2 arm
attachment plate LH with the nut.
3. INSTALL INNER NO. 1 ARM ATTACHMENT PLATE LH
(a) Install the inner No. 1 arm attachment plate LH and spacers with the 3 bolts.
Torque: 32 Nm (326 kgf-cm, 24 ft-lbf)
4. INSTALL INNER NO. 2 ARM ATTACHMENT PLATE LH
(a) Install the inner No. 2 arm attachment plate LH and spacer with the 2 bolts.
Torque: 32 Nm (326 kgf-cm, 24 ft-lbf)
5. INSTALL FRONT PNEUMATIC CYLINDER O-RING LH See: Suspension Strut / Shock Absorber/Service and Repair/Removal and
Replacement/Front Shock Absorber (W/ Air Suspension)/Installation
6. INSTALL FRONT PNEUMATIC SHOCK ABSORBER WITH CYLINDER ASSEMBLY LH See: Suspension Strut / Shock Absorber/Service
and Repair/Removal and Replacement/Front Shock Absorber (W/ Air Suspension)/Installation
7. INSTALL ABSORBER CONTROL ACTUATOR See: Suspension Strut / Shock Absorber/Service and Repair/Removal and Replacement/Front