LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-2367002.png)
SUSPENSION CONTROL: FRONT ACCELERATION SENSOR: REMOVAL
REMOVAL
1. REMOVE COWL TOP VENTILATOR LOUVER RH See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
NOTE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and
settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery
terminal.
3. REMOVE INSTRUMENT SIDE PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal
4. REMOVE NO. 1 INSTRUMENT CLUSTER MOULDING See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Removal
5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal
6. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal
7. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver Side Knee
Airbag Assembly/Removal
8. REMOVE ACCELERATION SENSOR ASSEMBLY
(a) Disconnect the sensor connector.
(b) Remove the bolt and acceleration sensor with bracket from the instrument panel reinforcement.
-
Avoid any impact to the acceleration sensor.
-
Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
-
The acceleration sensor removed from the vehicle must not be placed upside down.
Installation
SUSPENSION CONTROL: FRONT ACCELERATION SENSOR: INSTALLATION
INSTALLATION
1. INSTALL ACCELERATION SENSOR ASSEMBLY
(a) Install the acceleration sensor with bracket to instrument panel reinforcement with the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
-
Avoid any impact to the acceleration sensor.
-
Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
