LS 460 RWD V8-4.6L (1UR-FSE) (2010)
HINT
Tape the screwdriver tip before use.
(b) Remove the speaker panel.
7. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY
(a) Remove the 2 bolts.
(b) Remove the speaker and disconnect the speaker connector.
NOTICE:
Do not touch the cone part of the speaker.
Installation
AUDIO / VISUAL: INSTRUMENT PANEL SPEAKER: INSTALLATION
HINT
*
Use the same procedures for the LH side and RH side.
*
The procedures listed below are for the LH side.
*
A bolt without a torque specification is shown in the standard bolt chart See: Testing and Inspection/Programming and
Relearning.
1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY
(a) Connect the connector.
(b) Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.
(c) Install the speaker with the 2 bolts.
NOTICE:
*
Do not touch the cone part of the speaker.
*
When installing the speaker to the instrument panel be careful that get caught the wires do not get caught between the parts.
2. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY