LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Acceleration/Deceleration Sensor: Service and Repair
Installation
BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR: INSTALLATION
NOTICE:
While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or
the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and
open/close the doors while the battery is connected.
1. INSTALL YAW RATE SENSOR
(a) Connect the sensor connector.
(b) Install the sensor with the 2 bolts.
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
*
Make sure the yaw rate sensor's identification number is 9.
*
Do not drop the yaw rate sensor. If it is dropped, do not use it.
*
Do not mistaken the installation direction of the yaw rate sensor.
*
When installing the yaw rate sensor, make sure to avoid impact to the sensor.
*
After the installation, check that the yaw rate sensor is not tilted due to the floor carpet or any foreign matter.
2. INSTALL NO. 1 CONSOLE BOX DUCT
(a) Install the No. 1 duct with the 2 clips (labeled A).
(b) Attach the connector clamp (labeled B).
3. INSTALL CONSOLE BOX ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Front Console Box (w/o Rear Seat Entertainment System)/Installation
4. INSTALL CONSOLE COVER LOWER See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Front Console Box (w/o Rear Seat Entertainment System)/Installation
5. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Removal and Replacement/Front Console Box (w/o Rear Seat Entertainment System)/Installation
6. INSTALL CONSOLE PANEL SUB-ASSEMBLY UPPER See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal
and Replacement/Front Console Box (w/o Rear Seat Entertainment System)/Installation
7. INSTALL REAR CONSOLE PANEL UPPER See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and
Replacement/Front Console Box (w/o Rear Seat Entertainment System)/Installation
8. INSTALL NO. 3 BOX PANEL See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Front
Console Box (w/o Rear Seat Entertainment System)/Installation
9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and