LS 460 RWD V8-4.6L (1UR-FSE) (2010)
17. REMOVE SKID CONTROL ECU See: Electronic Brake Control Module/Service and Repair/Removal
18. REMOVE SKID CONTROL ECU BRACKET See: Electronic Brake Control Module/Service and Repair/Removal
19. DISCONNECT NO. 3 RELAY BLOCK
(a) While pushing the claw of the No. 3 relay block, pull out the No. 3 relay block and disconnect it from the reservoir bracket.
NOTICE:
Do not allow brake fluid to contact the No. 3 relay block.
20. REMOVE BRAKE FLUID RESERVOIR See: Hydraulic System/Brake Master Cylinder/Service and Repair/Removal and
Replacement/Removal
21. REMOVE NO. 1 RESERVOIR HOSE See: Hydraulic System/Brake Master Cylinder/Service and Repair/Removal and Replacement/Removal
22. REMOVE RESERVOIR BRACKET See: Hydraulic System/Brake Master Cylinder/Service and Repair/Removal and Replacement/Removal
23. REMOVE FRONT WHEEL
24. DISCONNECT BRAKE TUBE
(a) Using a union nut wrench, disconnect the 6 brake tubes from the actuator.
(b) Use tags or make a note to identify the reconnection locations.
*
*1: To FR RH
*
*2: To FR LH
*
*3: To: RR RH
*
*4: To RR LH
*
*5: From Master Cylinder
*
*6: From Stroke Simulator