LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(c) Using a union nut wrench, disconnect the No. 1 (labeled A) and No. 2 (labeled B) brake actuator tubes.
NOTICE:
Do not damage the No. 1 and No. 2 brake actuator tubes.
25. REMOVE BRAKE ACTUATOR AND BRAKE ACCUMULATOR PUMP ASSEMBLY
(a) Release the lock lever and disconnect the brake actuator connector.
NOTICE:
Do not allow brake fluid to contact the connector face.
(b) Disconnect the No. 1 brake actuator hose from the clamp and then remove the clamp.
(c) Disconnect the front fender liner rear side and then remove the 2 nuts (labeled A).
(d) Remove the bolt (labeled B) and brake actuator and brake accumulator pump.
NOTICE:
*
Do not damage the brake tubes.
*
When removing the brake actuator and brake accumulator pump from the vehicle, do not hold the connector, harness, hose or
tube parts.
*
Do not drop the brake actuator and brake accumulator pump. Do not use parts that have been dropped.
26. REMOVE NO. 5 BRAKE ACTUATOR BRACKET