LS 460 RWD V8-4.6L (1UR-FSE) (2010)
3. REMOVE V-BANK COVER SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Removal
4. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle
Body/Service and Repair/Removal
5. REMOVE NO. 1 AIR CLEANER INLET See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Removal
6. REMOVE ENGINE ROOM SIDE COVER RH See: Engine/Service and Repair/Removal and Replacement/Engine/Removal
7. REMOVE ENGINE ROOM SIDE COVER LH See: Engine/Service and Repair/Removal and Replacement/Engine/Removal
8. REMOVE NO. 1 ENGINE UNDER COVER See: Coolant/Service and Repair
9. DRAIN ENGINE COOLANT See: Coolant/Service and Repair
10. DISCONNECT NO. 1 RADIATOR HOSE
11. DISCONNECT NO. 2 RADIATOR HOSE
12. REMOVE ECM OUTLET DUCT See: Engine/Service and Repair/Removal and Replacement/Engine/Removal
13. REMOVE RADIATOR RESERVOIR ASSEMBLY See: Thermostat/Service and Repair/Removal
14. REMOVE FAN SHROUD WITH FAN AND MOTOR
(a) Disconnect the cooling fan ECU connector.
(b) Using a clip remover, detach the 3 clamps.
(c) Detach the 3 claws, and then remove the fan shroud with fan and motor.
Installation