LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(b) Apply seal packing in a continuous line as shown in the illustration.
Seal packing:
Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent
Standard seal diameter:
3.5 to 4.0 mm (0.138 to 0.158 in.)
NOTICE:
*
Remove any oil from the contact surface.
*
Install the camshaft housing within 3 minutes and tighten the bolts within 15 minutes after applying seal packing.
*
Do not start the engine for at least 2 hours after the installation.
(c) Install the camshaft housing, and install the 12 bolts in the order shown in the illustration.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf for bolt A)
Torque : 30 Nm (306 kgf-cm, 22 ft-lbf for except bolt A)
NOTICE:
Make sure that the knock pin of the camshaft is positioned as shown in the illustration before installing the camshaft housing.
(d) Tighten the 8 bolts in the order shown in the illustration.