LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Return the shift lever to P and disconnect terminal 13 (TC).
(h) Idle the engine to raise the temperature of the ATF.
(i) When the indicator light (D) turns on, raise the vehicle immediately.
Indicator Light Indicates the ATF Temperature:
NOTICE:
Perform the fluid level inspection while the indicator light is on.
(j) Remove the overflow plug. At the proper fluid inspection temperature, check the fluid amount.
(k) If the ATF flows from the overflow tube in a thin stream, the fluid amount is normal.
If the ATF does not flow from the overflow tube, remove the refill plug, and then add ATF into the refill hole until ATF flows from the
overflow tube.
(l) Install a new gasket and the overflow plug.
Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)