LS 460 RWD V8-4.6L (1UR-FSE) (2010)
NOTICE:
Make sure the flywheel housing cover is as shown in the illustration.
(d) Install the wire harness with the nut.
Torque : 9.8 Nm (100 kgf-cm, 88 in-lbf)
(e) Connect the starter connector.
(f) Install the terminal upper cover.
2. INSTALL NO. 3 EXHAUST MANIFOLD HEAT INSULATOR
(a) Install the heat insulator with the 3 bolts.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)
3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service and
Repair/Installation
4. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service
and Repair/Installation
5. INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine/Installation
6. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH