LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
the instrument panel.
HINT: Tape the screwdriver tip before use.
(b) Remove the speaker panel by hand.
NOTE: Remove instrument panel related parts by hand. Do not use a remover or screwdriver to pry instrument panel related parts as the
instrument panel's surface will be damaged.
10. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY
(a) Remove the 2 bolts.
(b) Remove the speaker and disconnect the speaker connector.
NOTE: Do not touch the cone part of the speaker.
Installation
AUDIO / VISUAL: INSTRUMENT PANEL SPEAKER: INSTALLATION
INSTALLATION
HINT:
-
Use the same procedures for the LH side and RH side.
-
The procedures listed below are for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard Bolt -
Specified Torque For Standard Bolts.
1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY
(a) Connect the connector.
(b) Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.
(c) Install the speaker with the 2 bolts.
-
Do not touch the cone part of the speaker.
-
When installing the speaker to the instrument panel be careful that get caught the wires do not get caught between the parts.