LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
(b) for Fixed Seat Type:
Install the floor end of the rear seat outer belt assembly center with the nut.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
NOTE: Do not allow the anchor part of the rear seat outer belt assembly to overlap the protruding parts of the floor panel.
(c) Check if the ELR locks.
NOTE: The check should be performed with the outer belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.
23. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type) See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for
Fixed Seat Type)/Installation
24. INSTALL REAR SEAT CUSHION ASSEMBLY LH
(a) for Power Seat:
(1) Remove the rear seat cushion assembly See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for Ottoman)/Installation.
(b) for Ottoman Seat:
(1) Remove the rear seat cushion assembly See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for Power Seat)/Installation.
25. INSTALL REAR SEAT CUSHION ASSEMBLY RH
(a) for Power Seat:
(1) Remove the rear seat cushion assembly See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for Ottoman)/Installation.
(b) for Ottoman Seat:
(1) Remove the rear seat cushion assembly See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for Power Seat)/Installation.
26. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
27. INSTALL BATTERY SERVICE HOLE COVER LH See: Starting and Charging/Battery
28. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY