LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
(a) Connect the No. 4 height control tube to the cylinder.
(b) Connect the No. 1 tube connector.
10. INSTALL AIR CONNECTOR CLIP HOLDER
(a) Install the air connector clip holder to the No. 1 tube connector.
11. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
(a) Install the front stabilizer link with the 2 nuts.
Torque: 85 Nm (867 kgf-cm, 63 ft-lbf)
HINT: If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.
12. CONNECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
(a) Install the bracket of the front height control sensor LH to the front No. 1 suspension lower arm LH with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
13. INSTALL STEERING KNUCKLE SUB-ASSEMBLY LH See: Wheel Hub/Service and Repair/Front Axle Hub/Installation
14. CONNECT FRONT NO. 1 SUSPENSION UPPER ARM ASSEMBLY LH See: Wheel Hub/Service and Repair/Front Axle Hub/Installation
15. CONNECT FRONT NO. 2 SUSPENSION UPPER ARM ASSEMBLY LH See: Wheel Hub/Service and Repair/Front Axle Hub/Installation
16. CONNECT TIE ROD ASSEMBLY LH See: Wheel Hub/Service and Repair/Front Axle Hub/Installation
17. INSTALL FRONT SPEED SENSOR LH See: Wheel Hub/Service and Repair/Front Axle Hub/Installation
18. CONNECT SKID CONTROL SENSOR WIRE See: Wheel Hub/Service and Repair/Front Axle Hub/Installation
19. INSTALL FRONT DISC BRAKE DUST COVER LH See: Wheel Hub/Service and Repair/Front Axle Hub/Installation