lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Front Shock Absorber|Page 10461 > < Front Shock Absorber|Page 10459
Page 11
background image

20. INSTALL FRONT DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Front Brake/Installation

                 

21. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH See: Wheel Hub/Service and Repair/Front Axle Hub/Installation

                 

22. INSTALL FRONT AXLE SHAFT NUT LH See: Control Arm/Service and Repair/Front Lower Suspension Arm/Installation

                 

23. INSTALL SERVICE PLUG GRIP See: Hybrid Drive Systems/Battery System, Hybrid Drive/Hybrid Battery Service Switch/Service and

Repair/Installation

                 

24. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected  See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.

25. INSTALL BATTERY SERVICE HOLE COVER See: Hybrid Drive Systems/Battery System, Hybrid Drive/Hybrid Battery Service Switch

                 

26. INSTALL BATTERY SERVICE HOLE COVER LH See: Starting and Charging/Battery

                 

27. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

                 

28. STABILIZE SUSPENSION

(a) Install the front wheels.

Torque: 140 Nm (1428 kgf-cm, 103 ft-lbf)

(b) Lower the vehicle and start the engine. Then fill the front pneumatic shock absorber with cylinder assembly LH with air.

HINT: If the vehicle height is not restored within 2 minutes, stop the engine and then start the engine again.

(c) Bounce the vehicle up and down several times to stabilize the front suspension.
(d) Remove the front wheels.

NOTE: Do not turn the power switch ON (IG).

(e) Jack up the front suspension lower arm with a wooden block between the jack and front suspension lower arm. Apply a load to the front

suspension so that the front suspension lower arm is horizontal.

29. TIGHTEN FRONT SHOCK ABSORBER BRACKET LOWER SUB-ASSEMBLY LH

(a) Tighten the lower side nut of the lower front shock absorber bracket sub-assembly LH.

Torque: 112 Nm (1142 kgf-cm, 83 ft-lbf)

30. INSTALL FRONT WHEEL

Torque: 140 Nm (1428 kgf-cm, 103 ft-lbf)

31. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(a) Check and adjust the front wheel alignment See: Alignment/Service and Repair/Front Wheel Alignment.

32. INSPECT FOR AIR LEAK

Front Shock Absorber|Page 10461 > < Front Shock Absorber|Page 10459