LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
(a) Install the sensor with the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
-
The speed sensor is easily damaged. When installing the speed sensor to the axle hub, do not use excessive force to rotate and install it.
-
Prevent foreign matter from attaching to the sensor tip.
-
Do not drop the sensor. If the sensor has been dropped, replace the sensor with a new one.
12. INSTALL FRONT SPEED SENSOR RH
HINT: Use the same procedures described for the LH side.
13. CONNECT SKID CONTROL SENSOR WIRE
(a) LH:
(1) Connect the connector to the front speed sensor.
(2) Install the sensor clamp with the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
(b) RH:
(1) Connect the connector to the front speed sensor.
(2) Install the sensor clamp with the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
14. INSTALL FRONT DISC BRAKE DUST COVER LH See: Wheel Hub/Service and Repair/Front Axle Hub/Installation
15. INSTALL FRONT DISC BRAKE DUST COVER RH
HINT: Use the same procedures described for the LH side.
16. INSTALL FRONT DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Front Brake/Installation
17. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH