LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
(a) Install the disc brake caliper with the 2 bolts.
Torque: 135 Nm (1377 kgf-cm, 100 ft-lbf)
18. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY RH
HINT: Use the same procedures described for the LH side.
19. INSTALL FRONT AXLE SHAFT NUT LH
(a) Clean the threaded parts on the drive shaft and axle shaft nut using a non-residue solvent.
NOTICE:
-
Be sure to perform this work for a new drive shaft.
-
Keep the threaded parts free of oil and foreign objects.
(b) Using a 30 mm socket wrench, install a new axle shaft nut.
Torque: 294 Nm (2998 kgf-cm, 217 ft-lbf)
NOTE: Do not stake the shaft nut.
HINT: Stake the shaft nut after the axle hub bearing looseness and axle hub runout inspections.
20. INSTALL FRONT AXLE SHAFT NUT RH
HINT: Use the same procedures described for the LH side.
21. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY LH See: Removal
22. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY RH See: Removal
23. REMOVE FRONT DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Front Brake/Removal
24. INSPECT FRONT AXLE HUB BEARING LOOSENESS See: Wheel Hub/Testing and Inspection/Front Axle Hub
25. INSPECT FRONT AXLE HUB RUNOUT See: Wheel Hub/Testing and Inspection/Front Axle Hub
26. INSTALL FRONT DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Front Brake/Installation
27. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH
(a) Install the disc brake caliper with 2 new bolts.
Torque: 135 Nm (1377 kgf-cm, 100 ft-lbf)