LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
_hybrid/Page-1730021.png)
(b) Install the clamp bolt.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)
28. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY RH
HINT: Use the same procedures described for the LH side.
29. INSTALL FRONT DISC BRAKE PAD WEAR INDICATOR WIRE ASSEMBLY RH (for RH Side)
(a) Connect the connector.
(b) Attach the wire harness clamp.
30. STAKE FRONT AXLE SHAFT NUT LH
(a) Using a chisel and hammer, stake the front axle shaft nut.
31. STAKE FRONT AXLE SHAFT NUT RH
HINT: Use the same procedures described for the LH side.
32. INSTALL FRONT WHEEL
Torque: 140 Nm (1428 kgf-cm, 103 ft-lbf)
33. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.6 Nm (57 kgf-cm, 50 in-lbf)
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
34. INSTALL BATTERY SERVICE HOLE COVER LH See: Starting and Charging/Battery
35. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
36. CHECK SUSPENSION CONTROL SYSTEM
(a) Check the suspension control system See: Steering and Suspension/Suspension/Adjustments.
37. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(a) Inspect and adjust the front wheel alignment See: Maintenance/Alignment/Service and Repair/Front Wheel Alignment.
38. CHECK ABS SPEED SENSOR SIGNAL
(a) Check the speed sensor signal See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial
Inspection and Diagnostic Overview/Test Mode Procedure.
39. ADJUST HEADLIGHT ASSEMBLY
(a) for HID Headlight:
