RX 300 FWD V6-3.0L (1MZ-FE) (1999)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
ABS Actuator
REMOVAL
1. REMOVE RIGHT FRONT WHEEL AND FRONT FENDER LINER
2. REMOVE PS GEAR TUBE CLAMP BOLT
Torque: 5.4 Nm (55 kgf.cm, 48 inch lbs.)
3. DISCONNECT ENGINE COOLANT RESERVOIR
Slide the engine coolant reservoir upward and remove it from the bracket.
4. DISCONNECT 2 CONNECTORS FROM ABS ACTUATOR ASSEMBLY
5. DISCONNECT BRAKE LINES
Using SST, disconnect the 6 brake lines from the ABS actuator assembly.
SST 09751 - 36011
Torque: 15 Nm (155 kgf.cm, 11 ft. lbs.)
6. REMOVE ABS ACTUATOR ASSEMBLY
Remove the 2 bolts, nut and ABS actuator assembly.
Torque: 19 Nm (195 kgf.cm, 14 ft. lbs.)
7. REMOVE ABS ACTUATOR
a. Remove the 2 nuts and ABS actuator from actuator bracket.
Torque: 5.4 Nm (55 kgf.cm, 48 inch lbs.)
b. Remove the 2 holders and 3 cushions from the ABS actuator.
INSTALLATION
Installation is in the reverse order of removal.
1. AFTER INSTALLATION, FILL BRAKE RESERVOIR WITH BRAKE FLUID AND BLEED BRAKE SYSTEM
2. CHECK FOR LEAKS