RX 330 AWD V6-3.3L (3MZ-FE) (2004)
^
To install the moon roof assembly, reverse the order of removal. Please note special points concerning the installation.
1. Remove roof headlining assembly.
2.
Remove sliding roof side garnish LH and RH.
Using a screwdriver, disengage the clip and remove the side garnish.
HINT:
Tape the screwdriver tip before use.
3.
Remove sliding roof glass sub-assembly. Using a torx driver (T25), remove the 4 screws and roof glass.
4.
Remove sliding roof housing sub-assembly.
A.
Disconnect the 4 hoses and drive gear connector.
B.
Remove the 8 bolts and 4 brackets.
C.
Remove the 8 nuts and housing.
5.
Remove sliding roof drive gear sub-assembly.
A.
Remove the drive gear bracket.
B.
Remove the 2 bolts and drive gear.
6.
Remove sunshade trim sub-assembly.