RX 330 AWD V6-3.3L (3MZ-FE) (2004)
Crankshaft Main Bearing: Specifications
Crankshaft bearing cap set bolt diameter
Standard ..................................................................................................................................................................... 7.5 to 7.6 mm (0.295 to 0.299 inch)
Minimum ........................................................................................................................................................................................... 7.2 mm (0.283 inch)
Main journal diameter ................................................................................................................................... 52.992 to 53.000 mm (2.0863 to 2.0866 inch)
Main journal taper and out-of-round
Maximum ....................................................................................................................................................................................... 0.02 mm (0.0008 inch)
Using several steps, install and tighten the 16 main bearing cap bolts uniformly in the sequence shown in the illustration.
Step 1 ................................................................................................................................................................................ 22 Nm (224 kgf-cm, 16 ft. lbs.)
Step 2 ................................................................................................................................................................................................................... Turn 90°
Using several steps, install and tighten the 8 main bearing cap bolts uniformly in the sequence shown in the illustration.
Torque .............................................................................................................................................................................. 27 Nm (275 kgf-cm, 20 ft. lbs.)