RX 330 FWD V6-3.3L (3MZ-FE) (2006)
5. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR
a. Install the height control sensor sub-assembly and nut to the suspension arm assembly No. 2 (w/ air suspension).
6. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR
a. Install the height control sensor link with the nut (w/ discharge head light).
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
HINT: Perform the procedure only when installing the RH side.
7. INSTALL REAR AXLE HUB& BEARING ASSEMBLY LH
a. Install the hub & bearing assembly LH with the 4 bolts.
Torque: 75 Nm (765 kgf-cm, 55 ft. lbs.)
8. INSPECT BEARING BACKLASH
9. INSPECT AXLE HUB DEVIATION
10. CONNECT SKID CONTROL SENSOR
a. Connect the connector.
NOTICE: Do not twist the sensor wire when connecting it.
11. INSTALL REAR DISC
12. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
a. Install the rear disc brake caliper with the 2 bolts.
Torque: 78 Nm (800 kgf-cm, 58 ft. lbs.)