RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
NOTICE:
*
Allow the primer to dry for 3 minutes or more.
*
Throw away any leftover primer.
*
Do not apply too much primer.
6. INSTALL BACK DOOR GLASS
(a) Using a brush, coat the installation surface on the vehicle body with Primer M.
NOTICE:
*
Do not coat the adhesive with Primer M.
*
Do not apply too much primer.
*
Allow the primer to dry for 3 minutes or more.
*
Throw away any leftover primer.
HINT
If an area other than that specified is coated by accident, wipe off the primer with a clean piece of cloth before it dries.
(b) Using a brush or a sponge, coat the application area of the adhesive with Primer G.
NOTICE:
*
Do not apply too much primer.
*
Allow the primer to dry for 3 minutes or more.
*
Throw away any leftover primer.
HINT
*
Apply Primer G onto the ceramic notches.
*
If an area other than that specified is coated by accident, wipe off the primer with a clean piece of cloth before it dries.
(c) Apply adhesive to the back door glass.
Adhesive:
Toyota Genuine Windshield Glass Adhesive or equivalent
(1) Cut off the tip of the cartridge nozzle as shown in the illustration.