RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
NOTICE:
*
Make sure that the differential mount cushion is aligned within 3° from the center.
*
Be sure to install the differential mount cushion in the correct direction.
(b) Using SST, press the differential mount cushion into the rear suspension member sub-assembly. (Step *1)
Text in Illustration
SST : 09570-48010
NOTICE:
*
Before using SST, apply grease to the SST bolts.
*
Install the SST bolts straight and tighten them equally.
(c) Using a vernier caliper, measure the length indicated by A in the illustration. (Step *2)
NOTICE:
*
Measure at several points to ensure that the differential mount cushion is pressed in evenly.
*
Do not measure on a weld bead.
(d) Repeat the steps *1 and *2 to press the differential mount cushion into the rear suspension member sub-assembly until the length indicated by
A in the illustration is within the specification.
Reference length (A):
6.5 to 7.5 mm (0.256 to 0.295 in.)
HINT
Reference length (A) = Standard length (B) + Thickness of SST
(e) Remove SST. Using a vernier caliper, measure the differential mount cushion protrusion length indicated by B in the illustration and ensure
that the measured length is within the specification.
Standard length (B):
0.5 to 1.5 mm (0.0197 to 0.0590 in.)
8. INSTALL REAR TRACTION WITH TRANSAXLE MOTOR ASSEMBLY (for AWD) See: Transmission and Drivetrain/Continuously