RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Variable Transmission/Transaxle/Service and Repair/Removal and Replacement/Q211 Hybrid Transaxle/Rear Traction Motor/Installation
9. INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Rear
Upper Arm/Installation
10. INSTALL REAR UPPER CONTROL ARM ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
11. INSTALL REAR SPEED SENSOR WIRE LH (for 2WD)
(a) Install the rear speed sensor wire LH with the 2 bolts and nut as shown in the illustration.
Bolt - Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
Nut - Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
Do not twist the rear speed sensor wire LH when connecting it.
12. INSTALL REAR SPEED SENSOR LH (for AWD)
HINT
Perform the same procedure as the rear speed sensor wire LH.
13. INSTALL REAR SPEED SENSOR WIRE RH (for 2WD)
(a) Install the rear speed sensor wire RH with the 2 bolts and nut as shown in the illustration.
Bolt - Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
Nut - Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
Do not twist the rear speed sensor wire RH when connecting it.
14. INSTALL REAR SPEED SENSOR RH (for AWD)
HINT
Perform the same procedure as the rear speed sensor wire RH.
15. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH (w/ HID, LED Headlight System)
(a) Install the rear height control sensor sub-assembly RH to the rear suspension member sub-assembly with the bolt (A) and 2 nuts.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)