RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
NOTICE:
Do not twist the rear height control sensor wire when connecting it.
(b) Install the rear height control sensor sub-assembly RH to the rear upper control arm assembly RH with the bolt (B).
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
16. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Air Suspension)
(a) Install the rear height control sensor sub-assembly LH to the rear suspension member sub-assembly with the bolt (A) and 2 nuts.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
NOTICE:
Do not twist the rear height control sensor wire when connecting it.
(b) Install the rear height control sensor sub-assembly LH to the rear upper control arm assembly LH with the bolt (B).
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
17. INSTALL REAR SUSPENSION MEMBER UPPER STOPPER
(a) Install the 2 rear suspension member upper stoppers as shown in the illustration.
NOTICE:
Be sure to install the rear suspension member upper stoppers in the correct direction shown in the illustration.
18. INSTALL REAR SUSPENSION MEMBER REAR UPPER STOPPER
(a) Install the 2 rear suspension member rear upper stoppers as shown in the illustration.
19. INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY
HINT
*
Use the same procedure for the 2WD and AWD.
*
The procedure listed below is for the AWD.
(a) Support the rear suspension member with a jack using 4 attachments or equivalent tools as shown in the illustration.
Text in Illustration