RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
(d) Install the screw.
Torque : 2.4 Nm (25 kgf-cm, 21 in-lbf)
6. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
7. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral
Cable/Service and Repair/Installation
8. INSTALL STEERING WHEEL ASSEMBLY
(a) Align the matchmarks on the steering wheel assembly and steering main shaft.
Text in Illustration
(b) Install the steering wheel assembly set nut.
Torque : 50 Nm (510 kgf-cm, 37 ft-lbf)
(c) Connect the connectors to the spiral cable sub-assembly.
9. INSTALL STEERING PAD
HINT
Refer to the instructions for Installation of the steering pad See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Removal and Replacement/Steering Pad/Installation.
10. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
*
Make sure that the cable has been disconnected from the battery terminal for at least 2 seconds before reconnecting the cable.
*
Connect the cable to the negative (-) battery terminal with the front wheels facing straight ahead.
*
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
12. INSPECT STEERING PAD See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and Replacement/Steering
Pad/Installation
13. PERFORM DIAGNOSTIC SYSTEM CHECK
See: Restraint Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes
14. INSPECT SRS WARNING LIGHT