3 L4-2.5L (2010)
^ This warranty information applies only to verified customer complaints on vehicles eligible for warranty repair.
^ This repair will be covered under Mazda's New Vehicle Limited Warranty term.
^ Additional diagnostic time cannot be claimed for this repair.
Disclaimer
Repair Procedure
1. Verify customer concern.
2. Remove the front seat from the vehicle. Refer to Workshop manual section 09-13 FRONT SEAT REMOVAL / INSTALLATION.
3. Remove the seat front cushion trim.
^ For vehicles with power seats, refer to Workshop manual section 09-13 FRONT SEAT COVER REMOVAL/INSTALLATION [VEHICLES WITH
POWER SEAT SYSTEM].
^ For vehicles without power seats, refer to Workshop manual section 09-13 FRONT SEAT COVER REMOVAL/INSTALLATION [VEHICLES
WITHOUT POWER SEAT SYSTEM].
NOTE:
The fittings (indicated with a circle) behind the side cover (A) are fragile. Release the fastener fitting at the front first to open up the front side, then
unhook the tab (B) from the reverse cover (C).
4. Strip off the seat cushion trim (A) from the seat cushion pad (B) by removing the hog "rings" (C).