3 L4-2.5L (2010)
Cylinder Head Removal Note
1. Loosen the cylinder head bolts in 2-3 steps in the order shown in the figure.
Cylinder Head Installation Note
1. Measure the length of each cylinder head bolt.
Cylinder Head Bolt Length L
-
145.2-145.8 mm {5.717-5.740 in}
Cylinder Head Bolt Maximum
-
146.5 mm {5.767 in}
-
Replace any that exceeds maximum length.
2. Tighten the cylinder head bolts in the order shown in the following 5 steps using the SST (49 D032 316).
Tightening torque
-
Step 1: 3-11 Nm {31-112 kgf-cm, 27-97 in-lbf}
-
Step 2: 13-17 Nm {133-173 kgf-cm, 116-150 in-lbf}
-
Step 3: 43-47 Nm {4.4-4.7 kgf-m, 32-34 ft-lbf}
-
Step 4: 88-92°
-
Step 5: 88-92°
Camshaft Installation Note
1. Apply the gear oil (SAE No.90 or equivalent) to each journal of the cylinder head as shown in the figure.