3 L4-2.5L (2010)
Tightening torque
-
8-10 Nm {82-101 kgf-cm, 71-88 in-lbf}
Bolt length measured from below the head
3. Match the harness colors, then connect each solenoid valves connector. Connector color (harness-side)
4. Install the GND.
Tightening torque
-
8-10 Nm {82-101 kgf-cm, 71-88 in-lbf}
5. Install the TFT sensor to the oil strainer.
6. Install the oil strainer.
7. Apply a light coat of silicon sealant (TB1217E) to the contact surfaces of the oil pan and transaxle case.
CAUTION:
-
If any old sealant gets into the transaxle during installation of the oil pan, trouble may occur in the transaxle case and oil pan, and clean with
cleaning fluids.