3 L4-2.5L (2010)
10. Measure the flatness of the pressure plate with a straight edge and a feeler gauge.
-
If it exceeds the maximum specification, replace the clutch cover. See: Service and Repair/Clutch Unit Removal/Installation [A26M-R]
Maximum clearance of flatness of the pressure plate
-
0.3 mm {0.01 in} max.
11. When checking the diaphragm spring fingers, mount a dial gauge on the cylinder block.
12. Rotate the flywheel and check for misaligned diaphragm spring fingers.
-
If it exceeds the maximum specification, replace the clutch cover. See: Service and Repair/Clutch Unit Removal/Installation [A26M-R]
Clutch cover diaphragm spring fingers maximum misalignment
-
1.0 mm {0.039 in} max.
13. Install in the reverse order of removal.
14. Perform the auto leveling system initialization. See: Lighting and Horns/Headlamp/Testing and Inspection/Programming and Relearning
15. Add the specified amount of specified transaxle oil. See: Manual Transmission/Transaxle/Service and Repair/Removal and
Replacement/Transaxle Oil Replacement [A26M-R]
16. Warm up the engine and transaxle, inspect for oil leakage, and inspect the transaxle operation.
WARNING:
-
Improperly jacking a transaxle is dangerous. It can slip off the jack and may cause serious injury.
NOTE:
-
If the transaxle is overhauled and installed to the vehicle, perform the 'INSPECTION AFTER TRANSAXLE OVERHAUL' and verify that there is
no abnormality. See: Manual Transmission/Transaxle/Service and Repair/Removal and Replacement/Inspection After Transaxle Installation
[A26M-R]
