323 L4-1600 1597cc (1986)
Please attach this copy which replaces page 2-13 of your owner's manual as shown in the following figure.
NOTE:
Some of the owner's manuals may have already been revised at the factory, therefore, please confirm the contents of your owner's manual on page 2-13.
If the "Installation on Front Seat" in your owner's manual is identical with that in the revised sheet enclosed the replacement is not required. Please
discard the replacement.
Please accept our apology for causing any inconvenience.
Sincerely, Mazda
Installation on Front Seat:
To install a child restraint system in the front of your vehicle a seat belt locking clip is required. Secure the child restraint with the lap belt, as shown in
the example illustration. To prevent looseness of the lap belt, use a genuine Mazda locking clip (pad number FA55 57 999, available from your Mazda
dealer) or one of equivalent dimensions and strength.
CHILD RESTRAINT SEAT SYSTEM
Type A (For 3-door models)
1.
Slide the seat to the rearmost position.
2.
Fasten the lap and shoulder belts over the child restraint system.
3.
Tighten the lap belt by pulling on the shoulder belt.
4.
To Install the locking clip, insert the lap and shoulder webbing through the recesses of the locking clip near the seat belt latch.
5.
If necessary, slide the seat forward to remove slack.
6.
After securing the belt by use of the locking clip, tuck the shoulder portion of the belt between the child restraint system and the seatback.
(REPLACEMENT PAGE 2-13)
LAP BELT ASSEMBLY
Type B (For 4-door and 5-door models)
1.
Slide the seat to the rearmost position.
2.
Fasten the lap and shoulder belts over the child restraint system, 3. Pull the lap belt out fully.
4.
Tie up the slack of the lap belt using the locking clip near the seatbelt latch as shown in the figure.
