6 L4-2.5L (2010)
Shift Interlock: Testing and Inspection
Shift-Lock Solenoid Inspection
SHIFT-LOCK SOLENOID INSPECTION
CAUTION:
-
Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
-
Do not damage the terminals.
1. Disconnect the selector lever component connector.
a. Disconnect the negative battery cable.
b. Remove the rear console. (See See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Rear
Console Removal/Installation.)
c. Disconnect the selector lever component connector.
2. According to the table, measure the voltage between selector lever component terminals and body GND.
-
If there is any malfunction, repair or replace the related wiring harness.
-
If there is no malfunction, replace the selector lever component. See: Shifter A/T/Service and Repair