6 V6-3.0L (2007)
3. Apply silicone grease to areas (A, B, C & D), spraying over each area 2-3 times.
4. Using a heat gun, apply heat to silicone until silicone is no longer sticky to the touch.
CAUTION:
DO NOT allow the heat gun to get too close to the surface of the seat. Too much heat may discolor the seat surface.
5. Verify repair.
WARRANTY INFORMATION
NOTE:
^ This warranty information applies only to verified customer complaints on vehicles eligible for warranty repair.
^ This repair will be covered under Mazda's New Vehicle Limited Warranty term.
^ Additional diagnostic time cannot be claimed for this repair.