6 V6-3.0L (2007)
1. Mark the new bushing as shown in the figure.
2. Press the bushing in to the marking using the SSTs.
3. Verify that clearance distance A-B is 12.75 - 14.75 mm (0.5020 - 0.5807 inch).
Clip Installation Note
1. Wipe the grease off the ball stud.
2. Fill the inside of the new dust boot with grease.
3. Install the boot on the ball joint.
4. Install the new clip using the SST.
5. Verify that the clip is installed securely to the groove.
6. Wipe away the excess grease.