6 V6-3.0L (2007)
Transmission Speed Sensor: Testing and Inspection
Intermediate Sensor Inspection
INTERMEDIATE SENSOR INSPECTION [FS5A-EL]
1. Connect the M-MDS, drive the vehicle, and verify the input value of the ISS PID.
^
If the input value is 0 rpm, perform the "Power Supply Voltage Inspection", "Open Circuit Inspection", or "Short Circuit Inspection".
^
If the input value is other than 0 rpm, perform the "Visual Inspection" or "Wave Profile Inspection".
Visual Inspection
1. Remove the intermediate sensor.
2. Make sure that the sensor is free of any metallic shavings or particles.
^
If any are found on the sensor, clean them off.
3. Install the intermediate sensor.
Wave profile Inspection
1. Remove the TCM.
2. Connect M-MDS to DLC connector.
3. Connect oscilloscope test leads to the following TCM connector terminals.
^
(+) lead: TCM terminal 2L
^
(-)lead: TCM terminal 1P
4. Start the engine.
5. Monitor VSS PID.
6. Inspect wave profile.
^
TCM terminal: 2L 1P
^
Oscilloscope setting: 1 V/DIV (Y), 2.5 ms/DIV (X), DC range
^
Vehicle condition: drive the vehicle with 32 km/h(20 mph)
-
If wave profile or voltage are out of specifications, carry out the "Open Circuit Inspection" or "Short Circuit Inspection"
Power Supply Voltage Inspection
1. Disconnect the intermediate sensor connector.
2. Turn the ignition switch to ON.
3. Measure voltage at intermediate sensor connector terminal B (wiring harness side).
Intermediate sensor voltage 4.5 - 5.5 V
