626 L4-1998 cc 2.0L SOHC Turbo FE (1986)
NOTE:
Reinstall relay to control box if previously removed.
18.
Reinstall the upper and lower 6 mm flange nuts and seal plates.
19.
Wiring of the thermostat.
a)
If the vehicle is 1986 model or 1987 MTX, perform the following procedure.
1)
Disconnect the G-15 coupler located under the evaporator case.
2)
Release the Red/Black (RB) male wire terminal from the G-15 coupler.
3)
Connect the RB wire to the thermostat harness using the single pin couplers supplied.
4)
Insert male terminal of thermostat harness into G-15 coupler as shown.
5)
Reconnect the G-15 coupler.
NOTE:
Make sure that the terminals are securely fastened.
6)
Connect the harness to the thermostat.
7)
Connect the short-circuited coupler to the thermistor connector on vehicle harness.