626 LX L4-2.0L DOHC (1999)
7. Remove the lock unit lock pin in the order shown in the figure.
Selector Cable Installation Note
1. Shift the selector lever and manual shaft to P position (KL), or D range (FS).
Caution: Bending the selector cable In the manner shown In the figure will damage the cable and cause It to become loose during shifting, when
handling and Installing the selector cable, hold It straight.
2. Install the selector cable to the cable bracket.
3. Install the clip to the selector cable.
4. Connect the selector cable to the manual shaft lever on the transaxle.
Selector Lever Installation Note
1. Install the selector lever.
2. Install the selector cable to the selector lever.
Tightening torque 16 - 22 Nm (1.6 - 2.3 kgf-m, 12 - 16 ft. lbs.)
3. Shift the selector lever to P position (KL), or D range (FS).
4. Connect the set button.