626 LX L4-2.0L DOHC (1999)
5. Slide the lock cover and lock the set button.
Indicator Panel Installation Note
1. Shift the selector lever to P position.
2. Align the alignment screws in the slider with the holes in the indicator panel. Install heavy-gauge wire to hold the slider.
3. Tighten the indicator panel screws in the order shown in the figure.
Tightening torque 2.0 - 2.9 Nm (20 - 30 kgf-cm, 18 - 26 inch lbs.)
4. Remove the heavy gauge wire.
5. Verify that the selector lever properly aligns with the indicator in each range.
