B3000 V6-3.0L (2007)
-
A repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
1. Depower the SRS. See DEPOWERING AND REPOWERING.
WARNING: The tighten torque of the air bag front impact severity sensor retaining nuts is critical for correct system operation.
NOTE:
-
Make sure the radiator support and front impact severity sensor mating surfaces are clean and debris free.
-
Note position of locator tab on sensor bracket for installation.
2. Remove the front impact severity sensor bolt
Tightening Torque: 12 N.m (1.2 kgf.m, 9 ft.lbf)
3. Disconnect the front impact severity sensor electrical connector and remove the sensor.
4. To install, reverse the removal procedure.
5. Repower the SRS. See DEPOWERING AND REPOWERING.