B3000 DS Cab Plus 2WD V6-3.0L OHV (2001)
Wheel Speed Sensor: Service and Repair
Toothed Ring
Front
FRONT SPEED SENSOR ROTOR (4X2) REMOVAL/INSTALLATION
1. Remove the disc plate.
2. Remove the speed sensor rotor from the disc plate using a 3-jaw puller.
3. Install in reverse order of removal, referring to Installation Note.
Front Speed Sensor Rotor Installation Note
1. Press the new speed sensor rotor on the disc plate using a cylinder with a 79 mm (3.1 inch) ID and a 96 mm (3.8 inch) OD.
Rear Axle
REAR AXLE SPEED SENSOR ROTOR (4WABS) REMOVAL/INSTALLATION
1. Remove the differential from the rear axle.
2. Remove the 10 bolts retaining the ring gear to the differential case.
3. Remove the ring gear, referring to Removal Note.
Note: Only remove speed sensor rotor if replacement is required. It does not have to be removed for ring bearing replacement.
4. Remove the speed sensor rotor by tapping with a soft-face hammer. Discard the speed sensor rotor.
Note: The rotor must be discarded upon removal. If removed, a new speed sensor rotor must be installed.
5. Install in reverse order of removal, referring to Installation Note
Ring Gear Removal Note
