mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Relays and Modules - Restraint Systems > < Diagram Information and Instructions|Page 208
Page 1
background image

Fuel Shut-off Solenoid Relay: Service and Repair

1. Disconnect the negative battery cable.

2. Access the fuel pump shutoff switch on the right side trim panel and disconnect the electrical connector.
3. Remove the bolts and remove the fuel pump switch.
4. Install in reverse order of removal.

Fuel Pump Shutoff Switch Reset Instructions

WARNING:  If you see or smell gasoline at any time other than during fueling, do not reset the inertia fuel shutoff (IFS) switch.

1. Turn key off.
2. Check for fuel leaks in the engine compartment.

3. If no leak is apparent, reset the IFS switch by pushing the reset button on the top of the switch (located behind the RH interior trim panel).

NOTE:  In the closed position, the button can be depressed an additional 1.57 mm (1/16 inch) against a spring.

4. Turn key to on or start position for a few seconds, then off again.
5. Check for leaking fuel.

Relays and Modules - Restraint Systems > < Diagram Information and Instructions|Page 208