B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
Power Steering Pump: Service and Repair
Power Steering Pump Pulley
REMOVAL
1. Remove the drive belt, refer to Engine.
2. Remove the power steering pump pulley, using the Pulley Remover Tool T69L-10-300B or equivalent.
INSTALLATION
CAUTION: Replacement of the power steering pump pulley is necessary after being removed and installed two times.
1. Install the power steering pump pulley.
(1) Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, discard the pulley. If there is no paint or one paint
mark, use a paint pencil to mark the web area of the pulley near the hub.
(2) Use the Pulley Replacer Tool T91P-3A-733A or equivalent.
2. Install the drive belt, refer to Engine.