B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
Band Apply Servo: Service and Repair
Reverse Servo
REVERSE SERVO ASSEMBLY REMOVAL / INSTALLATION
REMOVAL NOTE
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Drain the transmission fluid.
4. Remove the (1) bolt.
5. Remove the (2) oil strainer.
6. Remove the bolts.
7. Remove the reverse band servo cover and gasket. Discard the reverse servo separator plate cover gasket.
8. Remove the reverse band servo piston and rod and the reverse servo piston return spring.
Installation Note
1. Clean and inspect the reverse servo piston bore and the reverse band servo piston and rod.
2. Install the low/reverse band servo piston and rod into the servo bore along with a low/reverse servo return spring.