B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
Fluid Line/Hose: Service and Repair
TRANSMISSION COOLER TUBES REMOVAL / INSTALLATION
REMOVAL NOTE
1. Raise the vehicle on a hoist.
2. Disconnect the fluid cooler inlet tube and the fluid cooler tube from the radiator.
3. Disconnect the fluid cooler inlet tube and the fluid cooler tube from the transmission.
4. Remove the transmission fluid cooler line clip, the fluid cooler inlet tube and the fluid cooler tube from the engine from the engine.
INSTALLATION NOTE
1. Position the fluid cooler inlet tube and the fluid cooler tube. Install the transmission fluid cooler line clip on the engine.
2. Connect the fluid cooler inlet tube and the fluid cooler tube to the transmission.
Tightening torque: 44 - 58 Nm (4.5 - 5.9 kgf-m, 32 - 43 ft. lbs.).
3. Connect the fluid cooler inlet tube and the fluid cooler tube to the radiator.
Tightening torque: 44 - 58 Nm (4.5 - 5.9 kgf-m, 32 - 43 ft. lbs.).
