B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
Shifter A/T: Service and Repair
Manual Control Lever Shaft Seal Removal/Installation
MANUAL CONTROL LEVER SHAFT SEAL REMOVAL / INSTALLATION
REMOVAL
1. Disconnect the battery ground cable.
2. Raise and support the vehicle; refer to 00-00.
NOTE: It is not necessary to remove the oil strainer to perform this procedure.
3. Remove the oil pan.
4. Remove the digital Transmission Range (TR) sensor.
CAUTION: Do not damage the valve inner lever pin.
5. Remove the manual valve inner lever nut.
6. Remove the manual valve inner lever and the parking lever actuating rod.
CAUTION: Do not damage the case fluid pan rail.
7. Remove the manual control lever shaft spring pin.
1) Tap lightly on each side of the manual control lever shaft spring pin with a drift punch.
2) Pry the spring pin out of its bore.