mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

A/T - No 2nd/3rd Gear/No Engine Braking in 1st Gear|Page 3330 > < Transmission Temperature Sensor/Switch, A/T|Specifications
Page 1
background image

Valve Body: Customer Interest
A/T - No 2nd/3rd Gear/No Engine Braking in 1st Gear

Transmission/Transaxle

05-004/04

1995-2002 B-SERIES TRUCK - AUTOMATIC
TRANSMISSION - LOW LINE PRESSURE READING AT

WIDE OPEN THROTTLE AND/OR P0732, P0733, OR P1762

Note:

This bulletin supersedes the following TSB(s): 05-009/02. Please update your records accordingly.

BULLETIN NOTE

This bulletin supersedes 05-009/02 issued 8/13/2002. The DESCRIPTION, REPAIR PROCEDURE, PART(S) INFORMATION and WARRANTY
INFORMATION sections have been revised.

APPLICABLE MODEL(S)/VINS

1995-2002 Truck / B-Series with automatic transmission built prior to 12/1/2001.

DESCRIPTION

Some vehicles built prior to 12/1/2001 may exhibit the following shift and engagement conditions:

^

No 2nd Gear

^

No 3rd Gear

^

No Engine Braking In Manual 1st Gear

Line pressure that is out of specification may be the cause. Customers having this concern should have their vehicle repaired using the following repair
procedure.

NOTE:

This article does not apply to any other conditions or components that may cause similar symptoms and is only written to cover these specific
conditions.

REPAIR PROCEDURE

CAUTION

A new separator plate must be used when installing Valve Body Service Kit or additional transmission damage may occur. Refer to the PART(S)
INFORMATION table in this article for correct separator plate part listing.

NOTE:

An in-line service filter is not required to be added or replaced for this TSB.

1.

Verify customer concern.

2.

Verily that one or more of the following conditions exist:

A/T - No 2nd/3rd Gear/No Engine Braking in 1st Gear|Page 3330 > < Transmission Temperature Sensor/Switch, A/T|Specifications