B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
3. Slide the inboard driveshaft boot off the inboard CV joint housing.
4. Separate the CV joint from the CV joint housing.
5. Mark the shaft and the inboard CV joint to ease alignment during assembly.
6. Remove the snap ring.
7. Remove the CV joint.
8. Remove the inboard driveshaft boot from the shaft assembly.
9. Remove the two outboard boot clamps.
10. Remove the outboard driveshaft boot.
NOTE: If grease is contaminated, clean and inspect the joint for wear. Replace the outboard CV joint and shaft assembly if worn or damaged.
