B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
6. Install the CV joint on the driveshaft.
1) Line up the marks on the driveshaft and the CV joint.
2) Install the CV joint on the driveshaft.
7. Install the snap ring.
8. Lubricate the three CV joint needle bearings.
-
Use appropriate grease.
9. Fill the inboard CV joint housing with 235 grams of grease.
-
Use appropriate grease.
10. Position the CV joint housing onto the CV joint.
NOTE: Remove any excess grease from the inboard driveshaft boot mating Surface before positioning into place.
