B3000 SE Regular Cab 4WD V6-3.0L OHV (1998)
Caution
Do not get etching cream outside of the stencil, as damage to the windshield will occur.
3. Leave etching cream on the windshield for ONE (1) MINUTE ONLY. The AS1 lettering will blur if etching cream is left on the windshield longer
than one (1) minute.
4. Wash off etching cream with a damp cloth or paper towel and luke warm water.
5. After all traces of etching cream have been washed away, clean windshield with glass cleaner to remove any remaining stencil pieces.
CLEAN-UP
1. Continue to wear protective gear during clean-up.
2. Clean brushes with luke warm water.
3. Dispose of unused or etching cream container in accordance with state and local regulations after all stencils have been used.
C.
CAMPAIGN LABEL INSTALLATION
Complete an "Authorized Modifications Label" with the SSP number written on the sticker and affix to driver's side door under the door latch.
Refer back to the illustration under "A. VEHICLE INSPECTION PROCEDURE" on page one.
