CX-7 L4-2.3L Turbo (2007)
16. Remove the a 1.5 mm (0.059 in) round bar or similar from the lock unit holes A, B, and C.
17. Connect the brake switch connector with the brake pedal released.
Caution:
^
The clearance between the brake switch and the brake pedal is automatically adjusted to the correct amount when the brake switch
connector is connected after the brake switch has been properly installed. If the brake switch is not properly installed or the
connector is connected before installation, the clearance may be incorrect, causing a brake light malfunction. Therefore, always verify
that the brake switch is properly installed before connecting the connector.
^
Once the brake switch clearance has automatically been adjusted, it cannot be adjusted again. Therefore, replace the switch with a
new one when replacing the power brake unit or the pedal, or performing any procedure that changes the pedal stroke.
18. Turn the ignition switch to ON position.
19. Install the interlock cable to the steering lock.
20. Slide the outer casing to the steering lock and insert the clip over the convex part of the outer casing.
